Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY › from 2020.08
RM27T0E _51 Engine / Hybrid System _091546 STOP AND START _0437380 STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY G

STOP AND START  STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 84970F 1.INSPECT NO. 3 COMBINATION SWITCH ASSEMBLY (STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY)

a.
A462720C02
0.833,0.417 1,0.417 1,0.417 1.417,1.083 true 1.625,1.063 2.333,0.25 2.333,0.25 2.5,0.25 true 0.5,0.333 0.917,0.583 0.417,0.25 10 false ECU 2.583,0.167 2.833,0.333 0.25,0.167 10 false E 0.073,0.052 0.594,0.531 0.521,0.479 10 false *a
*a Component without harness connected
(No. 3 Combination Switch Assembly (Stop and Start System Cancel Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (E) - 4 (ECU) Pushed Below 1 Ω
Not pushed 10 kΩ or higher


If the result is not as specified, replace the No. 3 combination switch assembly (stop and start system cancel switch).


b.
A462720C01
1.854,1.417 2.083,1.917 2.083,1.917 2.417,1.917 true 0.729,1.313 1.365,1.313 true 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 2.5,1.833 2.917,2 0.417,0.167 10 false ILL- 0.375,1.229 0.708,1.396 0.333,0.167 10 false ILL+
*a Component without harness connected
(No. 3 Combination Switch Assembly (Stop and Start System Cancel Switch))


Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 8 (ILL+)
Battery negative (-) → 6 (ILL-)
Illuminates


If the result is not as specified, replace the No. 3 combination switch assembly (stop and start system cancel switch).