Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ Urea SCR System) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260461 ECD SYSTEM(w/ Urea SCR System) C

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  U110387  Lost Communication with Stop and Start Control Module Missing Message  


DESCRIPTION

The ECM and engine stop and start ECU send and receive signals via CAN communication.

If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
U110387 Lost Communication with Stop and Start Control Module Missing Message There is no communication between the ECM and engine stop and start ECU (1 trip detection logic).
·

ECM

·

Engine Stop and Start ECU

·

CAN Communication System


Dose not come on DTC stored SAE Code: U1103

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
U110387 Engine switch on (IG) for 5 seconds or more

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT (DTC U110387)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Read the DTCs using the GTS.


Result:
Result Proceed to
DTC U110387 is not output A
DTC U110387 is output B



A

B