Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › DPF SWITCH › from 2020.08
RM27T0E _51 Engine / Hybrid System _053675 1GD-FTV EMISSION CONTROL _0360750 DPF SWITCH G

1GD-FTV EMISSION CONTROL  DPF SWITCH  INSPECTION  


PROCEDURE

Hide 84970F 1.INSPECT NO. 3 COMBINATION SWITCH ASSEMBLY (DPF SWITCH)

a.
A472989C01
2.021,1.146 2.75,0.667 2.75,0.667 2.917,0.667 true 1.531,1.146 0.583,0.583 0.583,0.583 0.417,0.583 true 0.156,0.167 0.469,0.323 0.313,0.156 10 false *a 0.25,0.5 0.417,0.667 0.167,0.167 10 false E 3,0.583 3.25,0.75 0.25,0.167 10 false B
*a Component with out harness connected
(No. 3 Combination Switch Assembly (DPF Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3(E) - 1(B) Switch OFF 10 kΩ or higher
3(E) - 1(B) Switch ON Below 1 Ω


If the result is not as specified, replace the No. 3 combination switch assembly (DPF switch).


b.
A472989C02
1.833,1.417 2.667,1.75 2.667,1.75 2.833,1.75 true 1.417,1.417 0.667,1.75 0.667,1.75 0.5,1.75 true 0.156,0.167 0.469,0.323 0.313,0.156 10 false *a 0.167,1.667 0.5,1.833 0.333,0.167 10 false ILL+ 2.917,1.667 3.25,1.833 0.333,0.167 10 false ILL-
*a Component without harness connected
(No. 3 Combination Switch Assembly (DPF Switch))


Apply battery voltage between the terminals of the switch, and check the illumination condition of the No. 3 combination switch assembly (DPF switch).

OK:
Measurement Condition Specified Condition
Battery positive (+) → 8 (ILL+)
Battery negative (-) → 6 (ILL-)
Illuminates


If the result is not as specified, replace the No. 3 combination switch assembly (DPF switch).