23670
1.INSPECT INJECTOR ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Injector Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 6 | 20°C (68°F) | 0.52 to 0.66 Ω |
The temperature indicated in "Condition" is the temperature of the injector assembly.
If the result is not as specified, replace the injector assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 4 | 25°C (77°F) | 16.4 kΩ or less |
| 2 - 4 | 25°C (77°F) | 3.5 kΩ or less |
If the result is not as specified, replace the injector assembly.