FORWARD RECOGNITION CAMERA
DTCs may be detected when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.
Do not apply unnecessary loads as the connector may be damaged.
Check forward recognition camera
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| W22-3 (LKSW) - W22-10 (GND) | LDA switch signal | Ignition switch off, LDA switch not pressed | 1 MΩ or higher |
| Ignition switch off, LDA switch pressed | 228 to 252 Ω | ||
| W22-7 (IGB) - W22-10 (GND) | Power source | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| W22-10 (GND) - Body ground | Ground | Always | Below 1 Ω |