The following DTCs are output when there is a communication malfunction between the sensors or ECUs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, while the vehicle speed is 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the ECM is continuously detected for 5 seconds or more | CAN communication system |
| U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, while the vehicle speed is 5 km/h (3 mph) or more, a communication malfunction between the forward recognition camera and the G sensor (airbag sensor assembly) is continuously detected for 5 seconds or more | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the steering sensor is continuously detected for 5 seconds or more | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the skid control ECU (master cylinder solenoid) is continuously detected for 5 seconds or more | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | After 3 seconds or more have elapsed since turning the lane departure alert system on and the ignition switch to ON, a communication malfunction between the forward recognition camera and the combination meter assembly is continuously detected for 50 seconds or more | CAN communication system |
Clear the DTCs.
Make sure that the vehicle conditions when the DTC was stored are met.
If the detection conditions are not met, the system cannot detect malfunctions.
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B