The skid control ECU (master cylinder solenoid) sends signals such as brake request signals to the ECM. If an abnormal signal is detected, the ECM stores DTC P163081.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P163081 | Communication Error from VSC to ECM Invalid Serial Data Received | When the dynamic radar cruise control system is operating, the ECM detects abnormal data sent from the skid control ECU (master cylinder solenoid) for approximately 1 second or more. | ·
Vehicle stability control system (for hydraulic brake booster) ·
ECM |
Before replacing the ECM, refer to Service Bulletin.
Check for vehicle stability control system (for hydraulic brake booster) DTCs.
| Result | Proceed to |
|---|---|
| Vehicle stability control system (for hydraulic brake booster) DTCs are not output | A |
| Vehicle stability control system (for hydraulic brake booster) DTCs are output | B |
A
B
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P163081 is not output | A |
| DTC P163081 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B