The skid control ECU (master cylinder solenoid) sends signals such as brake request signals to the ECM. When the ECM detects logic error signals sent from the skid control ECU (master cylinder solenoid) for a certain period of time, DTC P163181 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P163181 | Communication Error from ECM to VSC Invalid Serial Data Received | When the ignition switch ON and the dynamic radar cruise control system is operating, the ECM detects logic error signals sent from the skid control ECU (master cylinder solenoid) for approximately 1 second or more. | ·
Vehicle stability control system (for hydraulic brake booster) ·
ECM |
Before replacing the ECM, refer to Service Bulletin.
Check for vehicle stability control system (for hydraulic brake booster) DTCs.
| Result | Proceed to |
|---|---|
| Vehicle stability control system (for hydraulic brake booster) DTCs are not output | A |
| Vehicle stability control system (for hydraulic brake booster) DTCs are output | B |
A
B
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P163181 is not output | A |
| DTC P163181 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B