Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM27T0E _58 Vehicle Interior _091549 PRE-COLLISION _0438246 PRE-COLLISION SYSTEM U

PRE-COLLISION  PRE-COLLISION SYSTEM  TERMINALS OF ECU  


CHECK FORWARD RECOGNITION CAMERA


NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

Do not apply larger loads than necessary since the connector may be damaged.



A417823E58
2.063,0.75 2.458,1.01 0.396,0.26 2.115,0.802 2.573,1 0.458,0.198 10 false W22

a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
W22-7 (IGB) - W22-10 (GND) Power source Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
W22-10 (GND) - Body ground Ground Always Below 1 Ω



CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY


Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT RADAR SENSOR SYSTEM>TERMINALS OF ECU