Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM27T0E _58 Vehicle Interior _091549 PRE-COLLISION _0438246 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C142571  Stop Light Relay Actuator Stuck  


DESCRIPTION

The skid control ECU (master cylinder solenoid) sends a stop light operation request signal to the stop light control relay (stop light switch assembly). When the skid control ECU (master cylinder solenoid) detects a malfunction relating to the stop light circuit, the forward recognition camera is notified via CAN communication, and C142571 is output.

DTC No. Detection Item DTC Detection Condition Trouble Area
C142571 Stop Light Relay Actuator Stuck Once 3 seconds elapse after turning the ignition switch to ON, the system receives a stop light circuit malfunction signal from the skid control ECU (master cylinder solenoid) for approximately 1 second or more. Vehicle stability control system

PROCEDURE

1.CHECK VEHICLE STABILITY CONTROL SYSTEM
a.

Check the vehicle stability control system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR

HINT:

When C142571 is detected by the pre-collision system, C1380 may also be detected in the vehicle stability control system. Therefore, check the vehicle stability control system first when C142571 is detected.



Result:
Proceed to
NEXT



NEXT

END