Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2020.08
RM27T0E _58 Vehicle Interior _091549 PRE-COLLISION _0438246 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U010087  Lost Communication With ECM/PCM "A" Missing Message  U012587  Lost Communication With Multi-axis Acceleration Sensor Module Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication With ECM/PCM "A" Missing Message While the vehicle is being driven at 5 km/h (3 mph) or more, a communication error between the ECM and the forward recognition camera is detected for approximately 6 seconds or more. CAN communication system
U012587 Lost Communication With Multi-axis Acceleration Sensor Module Missing Message While the vehicle is being driven at 5 km/h (3 mph) or more, a communication error between the yaw rate sensor (airbag sensor assembly) and the forward recognition camera is detected for approximately 4 seconds or more. CAN communication system
U012687 Lost Communication with Steering Angle Sensor Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the steering sensor and the forward recognition camera is detected for approximately 1 second or more. CAN communication system
U012987 Lost Communication with Brake System Control Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the skid control ECU (master cylinder solenoid) and the forward recognition camera is detected for approximately 1 second or more. CAN communication system

PROCEDURE

1.CHECK FOR DTC

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Recheck for DTCs and check that no DTCs are output.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

OK:

U010087, U012587, U012687 and U012987 are not output.



Result:
Proceed to
OK
NG



OK

NG