This DTC is stored when there is a malfunction in the ECM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P057504 | Cruise Control System Internal Failure | While the cruise control system is operating, the cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM. | ECM |
| P057549 | Cruise Control Internal Electronic Failure | When the ignition switch is ON, STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more. | ECM |
Before replacing the ECM, refer to the Service Bulletin.
The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch off.
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for i-ART)>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for i-ART)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC P057504 and P057549 are not output. | A |
| DTC P057504 and/or P057549 are output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B