Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (except i-ART) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0438250 CRUISE CONTROL SYSTEM(except i-ART) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(except i-ART)  U0122  Lost Communication With Vehicle Dynamics Control Module  


DESCRIPTION

The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0122 Lost Communication with Vehicle Dynamics Control Module While vehicle speed is 40 km/h (25 mph) or more and cruise switch (ON-OFF button) is on, data cannot be received from skid control ECU (brake actuator assembly)*1 or skid control ECU (master cylinder solenoid)*2 for 2.5 seconds or more.
·

Skid control ECU (brake actuator assembly)*1

·

Skid control ECU (master cylinder solenoid)*2

·

CAN communication system

·

ECM



*1: for Vacuum Brake Booster

*2: for Hydraulic Brake Booster

PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -/SET to begin control of vehicle speed using the cruise control system.




Result:
Result Proceed to
DTC U0122 is not output A
DTC U0122 is output B



A

B