17201
1.VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY
| *1 | Compressor Impeller |
Check for deformation and cracks in the compressor impeller on the intake side.
If the compressor impeller is cracked or deformed, replace the turbocharger sub-assembly.
| *1 | Turbine Wheel |
Check for deformation and cracks in the turbine wheel on the exhaust side.
If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.
17201
2.INSPECT AXIAL PLAY OF TURBINE SHAFT
Using a dial indicator, insert the needle of the dial indicator into the exhaust side of the turbine shaft.
Turbocharger sub-assembly and dial indicators are surely fixed when performing measurement.
Move the turbine shaft in the axial direction and measure the axial play of the turbine shaft.
0.11 mm (0.00433 in.)
If the axial play is more than the maximum, replace the turbocharger sub-assembly.
17201
3.CHECK TURBINE SHAFT ROTATION
Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.
Even if it takes a little effort to rotate the turbine wheel, this is not a problem.
If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.
17201
4.INSPECT TURBOCHARGER NOZZLE VANE CONTROL ACTUATOR
| *a | Component without harness connected
(Turbocharger Nozzle Vane Control Actuator) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 1 to 100 Ω |
The temperature indicated in "Condition" is the temperature of the turbocharger nozzle vane control actuator.
If the result is not as specified, replace the turbocharger nozzle vane control actuator.
Using a megohmmeter set to 500 V, measure the insulation resistance according to the value(s) in the table below.
Be sure to set the megohmmeter to 500 V when performing this test. Using a setting higher than 500 V can result in damage to the component being inspected.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (M-) - Body ground | Always | 10 MΩ or higher |
| 2 (M+) - Body ground | Always | 10 MΩ or higher |
If the result is not as specified, replace the turbocharger nozzle vane control actuator.