FREEZE FRAME DATA
Whenever a DTC is stored, the No. 1 headlight ECU sub-assembly and forward recognition camera stores the current vehicle (sensor) state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
Turn the ignition switch off.
Connect the GTS to the DLC3
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / AFS / DTC.
According to the display on the GTS, select the trouble code data display with Freeze Frame Data.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Clearance Light State | Clearance light state / OFF or ON | OFF: Clearance lights off
ON: Clearance lights on |
- |
| +B Voltage Value | No. 1 headlight ECU sub-assembly LH +B power supply voltage value / Min.: 0 V, Max.: 19.75 V | 11 to 14 V | - |
| Headlight Low Beam State | Low beam headlight state / OFF or ON | OFF: Low beam headlights off
ON: Low beam headlights on |
- |
| Headlight High Beam State | High beam headlight state / OFF or ON | OFF: High beam headlights off
ON: High beam headlights on |
- |
| DRL State | Daytime running light state / OFF or ON | OFF: Daytime running lights off
ON: Daytime running lights on |
- |
| Engine | Engine condition / Run or Stop | Run: Engine running
Stop: Engine stopped |
- |
| +B | No. 1 headlight ECU sub-assembly LH IG power supply voltage value / Min.: 0 V, Max.: 19.75 V | 11 to 14 V | - |
| FR Wheel Speed | Front right wheel speed / Min.: 0 km/h (0 mph), Max.: 260 km/h (162 mph) | Actual vehicle speed
Vehicle stopped: 0 km/h (0 mph) |
- |
| FL Wheel Speed | Front left wheel speed / Min.: 0 km/h (0 mph), Max.: 260 km/h (162 mph) | Actual vehicle speed
Vehicle stopped: 0 km/h (0 mph) |
- |
| Vehicle Acceleration | Vehicle acceleration / Min.: -455.64m/s2, Max.: 445.60 m/s2 | Condition can be displayed | - |
| Leveling Motor Slave | Status of the headlight leveling motor slave / Normal or Abnormal | Normal: Headlight leveling motor is normal
Abnormal: Headlight leveling motor is not normal |
- |
| Leveling Motor Over-Run | Status of the headlight leveling motor over-run / Normal or Abnormal | Normal: Headlight leveling motor is normal
Abnormal: Headlight leveling motor is not normal |
- |
| Height Sens Pw Supply Val | Rear height control sensor sub-assembly RH power supply value / Min.: 0 V, Max.: 6.25 V | 4.61 to 5.00 V | - |
| Rr Height Sens Signal Val | Rear height control sensor sub-assembly RH signal value / Min.: 0 V, Max.: 6.25 V | 0.50 to 4.50 V | - |
| Rear Height Sensor Value | Rear height control sensor sub-assembly RH signal value / Min.: -128 mm, Max.: 127 mm | Condition can be displayed | - |
| The Number of DTC | Number of trouble codes / 0 to 255 | Number of stored DTCs displayed | - |
w/ Automatic High Beam System:
Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.
According to the display on the GTS, select the trouble code data display with Freeze Frame Data.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Total Distance Traveled | Actual driving distance / 0 to 16777215 | Roughly the same as the actual driving distance | - |
| Total Distance Traveled - Unit | Actual driving distance unit / km or mile | Displays the current actual driving distance unit | - |
| AHB/AHS Information | Lighting system state / unknown, AHB or AHS | Displays lighting system state | - |
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the Freeze Frame Data.
Turn the ignition switch off.
Connect the GTS to the DLC3
Clear the DTCs and Freeze Frame Data.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>DTC CHECK / CLEAR