Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2020.08
RM27T0E _56 Audio / Visual / Telematics _053721 NAVIGATION / MULTI INFO DISPLAY _0441313 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU and radio and display receiver assembly.

WIRING DIAGRAM

E379207E23
5.052,0.802 5.51,1 0.458,0.198 10 false 7 5.302,0.906 5.76,1.104 0.458,0.198 10 false SUP 1.01,1.656 3.156,1.854 2.146,0.198 10 false Navigation ECU 5.229,1.656 6.458,2.125 1.229,0.469 10 false Radio and Display Receiver Assembly 5.229,1.51 5.906,1.792 0.677,0.281 10 false H94 1.01,1.51 3.156,1.708 2.146,0.198 10 false H96 2.021,0.802 2.479,1 0.458,0.198 10 false 21 1.583,0.917 2.042,1.115 0.458,0.198 10 false SUP

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the H94 radio and display receiver assembly connector.


b.

Disconnect the H96 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H94-7 (SUP) - H96-21 (SUP) Always Below 1 Ω
H94-7 (SUP) or H96-21 (SUP) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR