Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ACCELERATOR PEDAL › from 2020.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260463 ACCELERATOR PEDAL G

1GD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No.1 Voltage % and Accelerator Position Sensor No.2 Voltage %.


e.

Operate the accelerator pedal sensor assembly and check that the "Accelerator Position Sensor No.1 Voltage %" and "Accelerator Position Sensor No.2 Voltage %" values are within the specification.

Standard Voltage (Accelerator Position Sensor No.1 Voltage %):
Accelerator Pedal Condition Specified Condition
Released 10 to 22%
Depressed 52 to 90%


Standard Voltage (Accelerator Position Sensor No.2 Voltage %):
Accelerator Pedal Condition Specified Condition
Released 24 to 40%
Depressed 68 to 99%


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.