Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL BATTERY (for LHD) › from 2020.08
RM27T0E _58 Vehicle Interior _053730 DOOR LOCK _0326327 DOOR CONTROL BATTERY(for LHD) A

DOOR LOCK  DOOR CONTROL BATTERY(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT DISCHARGE DOOR CONTROL BATTERY AND DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Door Control Battery)

CAUTION:
·
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



HINT:
·

When the door control battery becomes completely discharged and the power supply is cut, the multiplex network body ECU (main body ECU) communication lost error "Lost communication with vehicle" appears on the GTS display.

·

The number of times the Active Test can be performed depends on the charge condition of the door control battery.



NOTICE:
·

Make sure to perform this procedure with the power supply of the battery and door control battery cut to prevent damage during removal and installation of the instrument panel junction block assembly.

·

Make sure to perform the following procedures, and then perform removal and installation of the instrument panel junction block assembly with the power supply from the battery and door control battery cut.



a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Active Test.

Body Electrical / Main Body / Active Test
Tester Display Control Range
Shock Detection Unlock UNLOCK/LOCK

NOTICE:

Do not perform the Active Test at this time.



e.

Disconnect the cable from the negative (-) battery terminal.


f.

Repeat the "Shock Detection Unlock" Active Test until the multiplex network body ECU (main body ECU) communication lost error "Lost communication with vehicle" appears on the GTS display.

Body Electrical / Main Body / Active Test
Tester Display
Shock Detection Unlock

HINT:
·

When the door control battery becomes completely discharged and the power supply is cut, the multiplex network body ECU (main body ECU) communication lost error "Lost communication with vehicle" appears on the GTS display.

·

The number of times the Active Test can be performed depends on the charge condition of the door control battery.




Hide 3.REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU

Hide 8598A 4.REMOVE DOOR CONTROL BATTERY (w/o Stop and Start System)

a.
B487075

Remove the nut.


b.

Detach the hook and remove the door control battery.


Hide 8598A 5.REMOVE DOOR CONTROL BATTERY (w/ Stop and Start System)

a.
B591032

Detach the 2 clamps and disconnect the connector.


b.
B591033

Remove the 2 nuts and remove the door control battery.