CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
Disconnect the H92 and H93 radio and display receiver assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specification |
|---|---|---|---|---|
|
*1: w/o Stop and Start System *2: w/ Stop and Start System |
||||
| H92-1 (GND1) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
| H92-4 (+B1) - H92-1 (GND1) | R - BR | Power source (+B) | Always | 11 to 14 V*1
10.5 to 16 V*2 |
| H92-15 (ACC1) - H92-1 (GND1) | GR - BR | Power source (ACC) | Ignition switch off | Below 1 V |
| Ignition switch on ACC | 11 to 14 V*1
10.5 to 16 V*2 |
|||
| H93-19 (IG) - H92-1 (GND1) | L - BR | Power source (IG) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
Reconnect the H92 and H93 radio and display receiver assembly connectors.
Measure the voltage, resistance and waveform according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specification |
|---|---|---|---|---|
| H93-30 (CA+) - H93-27 (CGND) | B - Shielded | Power source | Ignition switch ON | 5.5 to 7.05 V |
| H93-28 (V+) - H93-29 (V-) | R - W | Display signal | Ignition switch ON, camera lens not covered, displaying an image | Pulse generation (See waveform 1) |
| Ignition switch ON, camera lens covered, blacking out screen | Pulse generation (See waveform 2) | |||
| H93-27 (CGND) - Body ground | Shielded - Body ground | Shield ground | Always | Below 1 Ω |
| *a | Waveform 1 |
| *b | Waveform 2 |
| *c | Synchronized Signal |
| *d | Video Waveform |
Using an oscilloscope, check the waveform.
Waveform 1
| Item | Content |
|---|---|
| Terminal No. (Symbol) | H93-28 (V+) - H93-29 (V-) |
| Tool Setting | 200 mV/DIV., 50 μs/DIV. |
| Condition | Ignition switch ON, camera lens not covered, displaying an image |
The video waveform changes according to the image sent by the rear television camera assembly.
Waveform 2
| Item | Content |
|---|---|
| Terminal No. (Symbol) | H93-28 (V+) - H93-29 (V-) |
| Tool Setting | 200 mV/DIV., 50 μs/DIV. |
| Condition | Ignition switch ON, camera lens covered, blacking out screen |
The video waveform changes according to the image sent by the rear television camera assembly.