Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86101
1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
82171
2.INSTALL NO. 1 ROOF WIRE
Apply butyl tape to the roof headlining so that the tape is aligned with the wire harness marking as shown in the illustration.
Use butyl tape that has a width of 10 mm (0.394 in.).
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *a | Wire Harness Marking | *b | Butyl Tape |
Align the No. 1 roof wire with the wire harness installation points as shown in the illustration and attach it to the roof headlining assembly to install it.
Be sure to securely attach the roof wire so that it is not twisted.
Attach each clamp.
Make sure the each wire harness are securely set into the cutouts of the roof headlining assembly.
Turn the visor connectors approximately 90° clockwise to install them to the roof headlining assembly.
| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *C | w/ Rain Sensor, for LHD | *D | w/ EC Mirror |
| *E | w/ Rain Sensor, for RHD | *F | w/ Pre-collision System |
| *a | Visor Connector | *b | Wire Harness Installation Point |
81340J
3.INSTALL VANITY LIGHT ASSEMBLY LH
81340H
4.INSTALL VANITY LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
63344
5.INSTALL NO. 4 ROOF SILENCER PAD (w/o Sliding Roof)
Align the No. 4 roof silencer pad with the markings on the roof headlining assembly and install the No. 4 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.
63342
6.INSTALL NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)
Align the No. 2 roof silencer pad with the markings on the roof headlining assembly and install the No. 2 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.
63341
7.INSTALL NO. 1 ROOF SILENCER PAD
w/o Sliding Roof:
Align the 3 No. 1 roof silencer pads with the markings on the roof headlining assembly and install the 3 No. 1 roof silencer pads to the position shown in the illustration using hot-melt glue or double-sided tape.
w/ Sliding Roof:
Align the No. 1 roof silencer pad with the markings on the roof headlining assembly and install the No. 1 roof silencer pad to the position shown in the illustration using hot-melt glue or double-sided tape.