Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1630  Communication Error from VSC to ECM  


DESCRIPTION

The skid control ECU (master cylinder solenoid) sends signals such as brake request signals to the ECM. If an abnormal signal is detected, the ECM stores DTC P1630.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1630 Communication Error from VSC to ECM When the dynamic radar cruise control system is operating, the ECM detects abnormal data sent from the skid control ECU (master cylinder solenoid) for approximately 1 second or more.
·

Vehicle stability control system (for hydraulic brake booster)

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster))
a.

Check for vehicle stability control system (for hydraulic brake booster) DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR


Result:
Result Proceed to
Vehicle stability control system (for hydraulic brake booster) DTCs are not output A
Vehicle stability control system (for hydraulic brake booster) DTCs are output B



A

2.CHECK FOR DTC

B

2.CHECK FOR DTC

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.




Result:
Result Proceed to
DTC P1630 is not output A
DTC P1630 is output B



A

B