Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053696 CRUISE CONTROL _0260748 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1631  Communication Error from ECM to VSC  


DESCRIPTION

The skid control ECU (master cylinder solenoid) sends signals such as brake request signals to the ECM. When the ECM detects logic error signals sent from the skid control ECU (master cylinder solenoid) for a certain period of time, DTC P1631 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1631 Communication Error from ECM to VSC When the ignition switch is ON and the dynamic radar cruise control system is operating, the ECM detects logic error signals sent from the skid control ECU (master cylinder solenoid) for approximately 1 second or more.
·

Vehicle stability control system (for hydraulic brake booster)

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.CHECK FOR DTCs
a.

Check for vehicle stability control system (for hydraulic brake booster) DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM (for Hydraulic Brake Booster)>DTC CHECK / CLEAR


Result:
Result Proceed to
Vehicle stability control system (for hydraulic brake booster) DTCs are not output A
Vehicle stability control system (for hydraulic brake booster) DTCs are output B



A

2.CHECK FOR DTC

B

2.CHECK FOR DTC

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.




Result:
Result Proceed to
DTC P1631 is not output A
DTC P1631 is output B



A

B