The ECM communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication With ECM/PCM "A" | When the dynamic radar cruise control system is operating, a communication malfunction between the skid control ECU (master cylinder solenoid) and ECM is detected for approximately 1 second or more. | CAN communication system |
| U0104 | Lost Communication with Cruise Control Module | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the millimeter wave radar sensor assembly and ECM is detected for approximately 1 second or more. | CAN communication system |
| U0122 | Lost Communication With Vehicle Dynamics Control Module | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the skid control ECU (master cylinder solenoid) and ECM is detected for approximately 2.6 seconds or more. | CAN communication system |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG