Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
2. PRECAUTION
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Disable the auto tilt away function by changing the customize parameter
Click hereSteering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS
Record the current customize parameter setting (whether the auto tilt away function is enabled or disabled) in order to restore the current setting after finishing the operation.
Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
45287
5.REMOVE STEERING COLUMN LOWER COVER
Remove the 3 screws.
Detach the 2 claws and remove the steering column lower cover.
Do not damage the tilt and telescopic switch.
89235A
6.REMOVE TILT AND TELESCOPIC SWITCH
Disconnect the connector.
Detach the claw and pull out the tilt and telescopic switch.
Pushing on the claw too hard will break the claw.