When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes intermittently, an open in one of the wires of a CAN bus branch line is suspected.
If there is an ECU or sensor whose connection status changes intermittently while checking the "Communication Bus Check" screen, there may be an open circuit in one of the wires of a branch line of an ECU or sensor in the bus. If an open occurs in one of the wires of a CAN branch line, it may interfere with the communication of other ECUs or sensors resulting in an incorrect state being displayed.
| Symptom | Trouble Area |
|---|---|
|
*1: w/ Entry and Start System *2: for 1GR-FE, 1GD-FTV, 2TR-FE with Pre-collision System *3: for 2TR-FE without Pre-collision System *4: w/ Tire Pressure Warning System *5: for LED Headlight *6: w/ Urea SCR System *7: w/ Stop and Start System |
|
| There is an ECU or sensor that is indicated as not communicating on the "Communication Bus Check" screen or whose connection status on the "Communication Bus Check" screen changes intermittently. | One side of CAN branch line is open, or output signals are incomplete.
·
Air conditioning amplifier assembly ·
Urea pump control ECU*6 ·
Certification ECU (smart key ECU assembly)*1 ·
Power steering ECU assembly ·
Master cylinder solenoid (skid control ECU)*2 ·
Brake actuator assembly (skid control ECU)*3 ·
Airbag sensor assembly ·
Steering sensor ·
Tire pressure warning ECU and receiver*4 ·
No. 1 headlight ECU sub-assembly LH*5 ·
Engine stop and start ECU*7 ·
Main body ECU (multiplex network body ECU) |
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the ignition switch to ON and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.
After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
Based on the vehicle equipment and specifications, confirm the systems that use CAN communication.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Using the GTS, perform "CAN Bus Check".
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM
Observe the screen for approximately 2 minutes to check for ECUs and sensors that are displayed as not communicating.
Perform the inspection as specified in the Problem Symptoms Table for the ECUs or sensors that are not communicating.
| Proceed to |
|---|
| NEXT |
NEXT