Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM › from 2020.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0260475 ECD SYSTEM D

1GD-FTV ENGINE CONTROL  ECD SYSTEM  INITIALIZATION  


INITIALIZATION PROCEDURE FOR DIESEL THROTTLE BODY ASSEMBLY, ELECTRIC EGR CONTROL VALVE ASSEMBLY AND TURBOCHARGER NOZZLE VANE CONTROL ACTUATOR


HINT:

When the diesel throttle body assembly, electric EGR control valve assembly* or turbocharger nozzle vane control actuator is replaced, perform initialization

*: w/ EGR System


a.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



b.

Turn the ignition switch off and wait for 30 seconds or more.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.



CRANK TIME COMPENSATION LEARNING VALUE CLEAR FUNCTION


·

This procedure uses the GTS to perform "Crank Time Compensation Learning Value Clear".

·

When replacing the crank angle sensor plate (crankshaft), perform "Crank Time Compensation Learning Value Clear".


HINT:
·

If an error occurs during compensation reset, check the vehicle condition, and then perform compensation reset again.

·

A communication malfunction may occur if there is a problem with the ECM, a wire harness or the connection to the DLC3. If the wire harnesses and the connection to the DLC3 are inspected and found to be normal, the ECM may be malfunctioning.



a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.

NOTICE:

Do not start the engine.



c.

Enter the following menus: Powertrain / Engine / Utility / Crank Time Compensation Learning Value Clear.


d.

When the first screen is displayed, check the vehicle condition and push "Next".


e.

When the screen indicating reset completion is displayed, push "Exit".



i-ART Learning Value Reset


NOTICE:
·

When the engine is started after the i-ART learned value is reset with the ignition switch ON, the value for "Injection Feedback Value" may indicate a malfunction momentarily. However, this is not a malfunction and is due to the i-ART learned value being reset. The value returns to normal once learning is begun.

·

When the battery cable is disconnected, reconnect the battery cable, turn the ignition switch to ON and wait 3 minutes or more before performing this procedure.



a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.

NOTICE:

Do not start the engine.



c.

Enter the following menus: Powertrain / Engine / Utility / i-ART Learning Value Reset.

·

3 minutes or more has elapsed after turning the ignition switch to ON and connecting the battery cable.

·

The engine is stopped.

·

Battery voltage is 8 V or higher.



d.

Select the cylinder to be reset.


e.

Press "Next".

HINT:

The reset is performed automatically after "Next" is selected.



f.

If the reset fails, confirm the following conditions and perform the reset again.

i.

Turn the ignition switch to ON.


ii.

Turn the ignition switch off and wait for 30 seconds or more.


iii.

Turn the ignition switch to ON and wait 3 minutes or more.


iv.

Battery voltage is 8 V or higher.



g.

When the screen indicating reset completion is displayed, push "Exit".