Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/ DPF) › from 2020.08
RM27T0E _51 Engine / Hybrid System _053660 1GD-FTV ENGINE CONTROL _0442647 ECD SYSTEM(w/ DPF) L

1GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  PRECAUTION  


INITIALIZATION AND REGISTRATION


NOTICE:

When replacing the ECM and/or any other components in the following chart, perform the corresponding utility items.


HINT:

When the ECM and one or more other components are replaced at the same time, perform the following utility items by following the instructions shown on the GTS display, starting with the ECM.

Replacement Part Utility Item
ECM
·

Learning Values Save

Click here(Click here)

·

Learning Values Write

Click here(Click here)

·

VIN Registration

Click here(Click here)


Engine assembly Clear Crank Time Compensation Learning Value Data
Click here(Click here)
Crankshaft position sensor plate Clear Crank Time Compensation Learning Value Data
Click here(Click here)
Air fuel ratio sensor Clear A/F Sensor Learning Value data
Click here(Click here)
Exhaust manifold converter sub-assembly Clear DPF Thermal Deterioration Data
Click here(Click here)
Diesel throttle body assembly Initialization
Click here(Click here)
Electric EGR control valve assembly
Turbocharger sub-assembly or Turbocharger nozzle vane control actuator


HINT:

When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing a new ECM, perform all of the initializations/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.



CATALYST RECORD OF DPF THERMAL DETERIORATION


HINT:

The ECM stores the history data of DPF catalyst thermal deterioration. This data is updated continuously and then converted to an 8-digit code and stored in the EEPROM. If the ECM determines that replacement of the exhaust manifold converter sub-assembly is required based on the thermal deterioration data, a DTC is stored to inform the driver.


a.

When only the exhaust manifold converter sub-assembly is replaced.

i.

After replacing the exhaust manifold converter sub-assembly, clear the thermal deterioration data stored in the ECM.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>INITIALIZATION



b.

When only the ECM is replaced.

i.

After replacing the ECM, input the original thermal deterioration data stored before replacement.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>REGISTRATION

HINT:
·

Read the thermal deterioration data stored in the ECM before replacement, and store the data in the GTS.

·

If the thermal deterioration data cannot be read, be sure to replace the exhaust manifold converter sub-assembly with a new one and initialize the ECM.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>INITIALIZATION






WHEN USING GTS


CAUTION:

Observe the following items for safety reasons:

-

Before using the GTS, read the instruction manual.

-

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

-

When driving the vehicle for testing purposes using the GTS, 2 persons are required. One drives the vehicle, and the other operates the GTS.