Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL PUMP ECU › from 2020.08
RM27T0E _51 Engine / Hybrid System _053667 1GR-FE FUEL _0260547 FUEL PUMP ECU A

1GR-FE FUEL  FUEL PUMP ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel pump ECU removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 89570A 3.REMOVE FUEL PUMP ECU

a.
A220754E01
0.054,0.119 0.327,0.285 0.273,0.166 12 *A 0.054,2.477 0.309,2.646 0.255,0.170 12 *B

Disconnect the 2 connectors.

Text in Illustration
*A w/o Air Suspension
*B w/ Air Suspension


b.

Remove the 2 bolts and fuel pump ECU.

NOTICE:

Make sure the fuel pump ECU is not subjected to physical shocks, such as being dropped, etc.