Home › Engine / Hybrid System › 1GD-FTV (FUEL) › FUEL SUB TANK › from 2020.08
RM27T0E _51 Engine / Hybrid System _053670 1GD-FTV FUEL _0260582 FUEL SUB TANK A

1GD-FTV FUEL  FUEL SUB TANK  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel sub tank sub-assembly removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 77606C 3.REMOVE NO. 2 FUEL TANK PROTECTOR

a.
A220841

Remove the 5 bolts and No. 2 fuel tank protector.


Hide 4.DISCONNECT FUEL HOSE

a.
A220849

Slide the 5 clamps and disconnect the fuel evaporation hose, fuel breather hose and 3 fuel hoses from the fuel tank vent tube sub-assembly.


Hide 77213B 5.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A220844

Loosen the clamp and disconnect the fuel tank to filler pipe hose from the filler pipe.


Hide 77269A 6.DISCONNECT FUEL TANK BREATHER HOSE

a.
A223265

Loosen the clamp and disconnect the fuel tank breather hose from the filler pipe.


Hide 77100Z 7.REMOVE FUEL SUB TANK SUB-ASSEMBLY

a.
A220842

Disconnect the fuel sender gauge connector.


b.

Set a transmission jack underneath the fuel sub tank sub-assembly.


c.
A220845

Remove the 4 bolts and disconnect the 2 fuel tank bands.


d.

Remove the fuel sub tank sub-assembly.


Hide 77010 8.REMOVE FUEL TANK VENT TUBE ASSEMBLY

a.
A220851

Detach the wire harness clamp.


b.

Remove the 8 screws and fuel tank vent tube assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



c.

Remove the gasket from the fuel tank vent tube assembly.


Hide 77213B 9.REMOVE FUEL TANK TO FILLER PIPE HOSE

a.
A220847

Loosen the clamp and remove the fuel tank to filler pipe hose from the fuel sub tank sub-assembly.


Hide 77269A 10.REMOVE FUEL TANK BREATHER HOSE

a.
A223266

Loosen the clamp and remove the fuel tank breather hose from the fuel sub tank sub-assembly.