The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the fuel sub tank sub-assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
77606C
4.REMOVE NO. 2 FUEL TANK PROTECTOR
Remove the 5 bolts and No. 2 fuel tank protector.
5.DISCONNECT FUEL HOSE
Disconnect the fuel evaporation hose, fuel breather hose and fuel hose.
77213B
6.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the fuel tank to filler pipe hose from the filler pipe.
77269A
7.DISCONNECT FUEL TANK BREATHER HOSE
Disconnect the fuel tank breather hose from the filler pipe.
77100Z
8.REMOVE FUEL SUB TANK SUB-ASSEMBLY
Disconnect the fuel sender gauge assembly connector.
Set an engine lifter underneath the fuel sub tank sub-assembly.
Remove the 4 bolts and disconnect the 2 fuel tank bands.
Remove the fuel sub tank sub-assembly.
77010
9.REMOVE FUEL TANK VENT TUBE ASSEMBLY
Detach the wire harness clamp.
Remove the 8 screws and fuel tank vent tube assembly.
Be careful not to bend the arm of the fuel sender gauge assembly.
Remove the gasket from the fuel tank vent tube assembly.
77213B
10.REMOVE FUEL TANK TO FILLER PIPE HOSE
Remove the fuel tank to filler pipe hose from the fuel sub tank sub-assembly.
77269A
11.REMOVE FUEL TANK BREATHER HOSE
Remove the fuel tank breather hose from the fuel sub tank sub-assembly.