Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2020.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261011 BLIND SPOT MONITOR SYSTEM W

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE BLIND SPOT MONITOR SYSTEM


a.

Customizing with the Techstream.

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the Techstream to the DLC3.


ii.

Turn the engine switch on (IG).


iii.

Turn the blind spot monitor system on.


iv.

Turn the Techstream on.


v.

Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.


vi.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
RCTA Function Switches the RCTA function on and off. ON 0:ON,1:OFF Blind Spot Monitor Sensor LH