| *a | Front view of wire harness connector
(to Map Light Assembly (Manual (SOS) Switch)) |
Disconnect the map light assembly (manual (SOS) switch) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| W7-17 (RRID) - Body ground | Ignition switch ACC | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W7-15 (GND1) - Body ground | Always | Below 1 Ω |
| W7-16 (GND2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG