Home › Engine / Hybrid System › 1GD-FTV (STARTING) › GLOW PLUG CONTROLLER › from 2020.08
RM27T0E _51 Engine / Hybrid System _053695 1GD-FTV STARTING _0260740 GLOW PLUG CONTROLLER A

1GD-FTV STARTING  GLOW PLUG CONTROLLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the glow plug controller removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Correction of steering angle neutral point Multi-terrain monitor system (Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane departure alert system Drive the vehicle straight ahead at 40 km/h (25 mph) or more for 10 seconds or more. (Click here)
Pre-collision system
Lighting system (EXT) (for LED Headlight)
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Vehicle stability control system (for Hydraulic brake booster) Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds. (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 76622D 3.REMOVE FRONT FENDER MUDGUARD LH

Hide 53806 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 28551 5.REMOVE GLOW PLUG CONTROLLER

A246625

a.

Disconnect the 4 connectors and clamp.


b.

Remove the 2 nuts and glow plug controller from the vehicle.


Hide 28559 6.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.


Hide 28559A 7.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.