Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
45287
3.REMOVE LOWER STEERING COLUMN COVER
Turn the steering wheel to the left as necessary to remove the screw.
Turn the steering wheel to the right as necessary to remove the screw.
for Power Tilt and Power Telescopic:
Remove the screw.
Detach the 2 claws and remove the lower steering column cover.
45286B
4.REMOVE UPPER STEERING COLUMN COVER
Detach the 4 clips and claw to remove the upper steering column cover.
84650
5.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Disconnect the 2 connectors.
Detach the claw and remove the windshield wiper switch assembly.