Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR › from 2020.08
RM27T0E _55 Steering _053719 STEERING GEAR / LINKAGE _0260966 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


PROCEDURE

Hide 45047 1.INSPECT TIE ROD END SUB-ASSEMBLY

a.
ZK08184

Install the nut.


b.

Flip the ball joint stud back and forth 5 times as shown in the illustration.


c.

Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and check the torque reading on the 5th turn.

Standard Torque:

1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)



Hide 2.INSPECT TOTAL PRELOAD

a.
C216927E01
1.628,0.862 2.057,0.492 2.057,0.492 2.369,0.492 false 2.415,0.412 2.643,0.582 0.228,0.170 10 *a 2.278,0.492 1.639,1.315 false

Place matchmarks as shown in the illustration.

Text in Illustration
*a Matchmark


b.

Temporarily install the 2 steering rack ends to the steering rack.

NOTICE:

Do not fully turn the steering rack without the steering rack ends installed as it may damage the oil seal in the rack housing.



c.
C215760E01
2.104,0.682 1.85,0.377 1.85,0.377 1.687,0.377 false 1.303,0.304 1.772,0.530 0.468,0.225 10 SST

Using SST, fully turn the steering rack right and left 10 times to settle it.

SST
09616-00011  


d.
C215761E01
2.115,0.67 2.008,0.288 2.008,0.288 1.848,0.288 false 1.481,0.208 1.808,0.364 0.327,0.156 10 SST

Using SST, turn the control valve and measure the preload.

SST
09616-00011  

Standard preload (turning):
Body Type Engine Type Specified Condition
for 5 Door for 1GR, 2TR, 1GD 1.6 to 2.3 N*m (16 to 23 kgf*cm, 14 to 20 in.*lbf)
for 5L 1.5 to 2.2 N*m (15 to 22 kgf*cm, 13 to 19 in.*lbf)
for 3 Door for 2TR, 1GD


If the turning torque is not as specified, replace the steering gear assembly.

HINT:
·

Measure the standard preload at the steering rack neutral point.

·

The steering control valve is fully turned when turned 3.0 times. Half of the distance from the fully turned position is the neutral point.




e.

After inspecting the preload, align the matchmarks.