This circuit sends the park/neutral position switch assembly signals to the clearance warning ECU.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the C159 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (RL) - 2 (RB) | Shift lever in R | Below 1 Ω |
| 1 (RL) - 2 (RB) | Shift lever not in R | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
(See pageDrivetrain>AC60F (AUTOMATIC TRANSMISSION / TRANSAXLE)>PARK / NEUTRAL POSITION SWITCH>REMOVAL)
Disconnect the C159 park/neutral position switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| C159-2 (RB) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Park/Neutral Position Switch Assembly) |
OK
NG
Disconnect the I8 clearance warning ECU connector.
Disconnect the C159 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I8-21 (RL) - C159-1 (RL) | Always | Below 1 Ω |
| I8-21 (RL) - Body ground | Always | 10 kΩ or higher |
OK
NG