Wear protective gloves. Sharp areas on the parts may injure your hands.
71940A
1.REMOVE REAR SEAT HEADREST ASSEMBLY
Remove the headrest.
71691H
2.REMOVE REAR NO. 2 SEAT CUSHION HINGE COVER
Using a moulding remover, detach the 6 claws.
Detach the 2 guides and remove the cover.
71691E
3.REMOVE REAR NO. 1 SEAT CUSHION HINGE COVER
Using a moulding remover, detach the 6 claws.
Detach the 2 guides and remove the cover.
71691K
4.REMOVE REAR NO. 4 SEAT CUSHION HINGE COVER
Operate the reclining release handle to move the seat into the position shown in the illustration.
Using a moulding remover, detach the claw and remove the cover.
71691J
5.REMOVE REAR NO. 3 SEAT CUSHION HINGE COVER
Using a moulding remover, detach the claw and remove the cover.
6.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
w/ Seat Belt Warning System:
Disconnect the floor wire harness connector.
Remove the 3 bolts, nut and seat.
Be careful not to damage the vehicle body.