Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL REAR SEAT ASSEMBLY LH
Place the rear seat assembly LH in the cabin.
Be careful not to damage the vehicle body.
Be sure to install the seat with the seatback folded down.
Connect the center inner belt to the rear seat assembly.
Temporarily install the seat with the 5 bolts and nut.
Tighten the bolts and nut in the order indicated in the illustration.
w/ Seat Wire Harness:
Connect the floor wire harness connector.
72138B
2.INSTALL SEAT TRACK COVER LH
Attach the 3 clips to install the seat track cover LH.
72158
3.INSTALL SEAT TRACK INNER BRACKET COVER LH
Attach the 6 clips to install the seat track inner bracket cover LH.
72159B
4.INSTALL REAR SEAT OUTER TRACK BRACKET COVER
Move the cover in the direction of the arrow to attach the 2 guides.
Attach the 2 claws to install the rear seat outer track bracket cover.
72152A
5.INSTALL REAR SEAT TRACK INNER BRACKET COVER
Attach the 2 claws and guide to install the rear seat track inner bracket cover.
71940A
6.INSTALL REAR SEAT HEADREST ASSEMBLY
Install the rear seat headrest assembly.
7.CHECK SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)