Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73380C
1.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
| *a | Protruding Part |
Install the inner belt with the bolt.
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.
w/ Seat Belt Warning System:
Attach the clamp and connect the connector.
2.INSTALL SEAT CUSHION COVER WITH PAD (w/ Seat Belt Warning System)
72615A
3.INSTALL REAR SEATBACK LOCK STRIKER COVER RH (w/ Seat Belt Warning System)
71829B
4.INSTALL REAR SEAT REAR CUSHION MOULDING LH
71825B
5.INSTALL REAR SEAT CUSHION MOULDING RH (w/ Seat Belt Warning System)
72525B
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH (w/ Seat Belt Warning System)
71845A
7.INSTALL REAR SEAT UPPER RECLINING COVER RH (w/ Seat Belt Warning System)
8.INSTALL REAR SEAT ASSEMBLY RH
Install the rear seat assembly RH (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type RH Side)>INSTALLATION).
9.CHECK SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)