Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM › from 2021.06
RM27T0E _56 Audio / Visual / Telematics _056796 TELEMATICS _0277431 TELEMATICS SYSTEM J

TELEMATICS  TELEMATICS SYSTEM  Emergency Call Switch Illumination Circuit  


WIRING DIAGRAM

E467088E02
4.188,2.323 6.344,2.542 2.156,0.219 10 false Map Light Assembly 4.854,1.771 6.938,1.979 2.083,0.208 10 false Manual (SOS) Switch 4.281,0.583 6.365,0.792 2.083,0.208 10 false RRID 4.302,1.25 6.385,1.458 2.083,0.208 10 false GND 3.073,0.906 5.156,1.115 2.083,0.208 10 false IGN 1.354,0.719 3.438,0.927 2.083,0.208 10 false from IG2 Relay 3.938,0.583 6.021,0.792 2.083,0.208 10 false 17 4,1.208 6.083,1.417 2.083,0.208 10 false 5 4.177,2.167 6.333,2.385 2.156,0.219 10 false W7

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAP LIGHT ASSEMBLY - BATTERY AND BODY GROUND)
a.
E467089C01
1.469,0.271 1.875,0.521 0.406,0.25 0.75,1.771 0.927,1.771 0.927,1.771 1.219,1.271 true 0.823,0.438 1,0.438 1,0.438 1.406,1.083 true 1.583,0.313 2.042,0.51 0.458,0.198 10 false W7 0.125,0.094 0.583,0.292 0.458,0.198 10 false *a 0.385,1.698 0.844,1.896 0.458,0.198 10 false RRID 0.479,0.333 0.938,0.531 0.458,0.198 10 false GND
*a Front view of wire harness connector
(to Map Light assembly)


Disconnect the map light assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
W7-17 (RRID) - Body ground Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W7-5 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR