2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter yoke.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install the brush holder.

  1. A215926
    Connect the 4 brushes to the starter brush holder.

    1. Using a screwdriver, hold back the spring.

    2. Connect the brush to the brush holder.

      NOTICE:
      Check that the positive (+) lead wire are not grounded.

  1. Place a new O-ring in position on the commutator end frame.

  1. Install a new dust protector to the commutator end frame.

  1. A223816
    Install the commutator end frame with the 2 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply high temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.

  1. A222255
    Insert the steel ball into the starter clutch shaft hole.

  1. Insert the return spring into the starter clutch shaft hole.

  1. Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.

    A223815E01

  1. A223814
    Install the starter drive housing to the magnet starter switch with the 2 screws.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. Align the claw of the starter yoke with the groove of the starter switch.

  1. A218208E01
    Install the starter yoke to the starter switch.

  1. A223813
    Install the 2 bolts.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Jan 2012)REASSEMBLY (from Jan 2012) →