2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

PRECAUTION

Precautions · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1.IGNITION SWITCH EXPRESSION
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Engine Switch (Condition)
    Ignition Switch off
    LOCK
    Off
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON
    ON
    On (IG)
    Engine Start
    START
    Start


2.INITIALIZATION

NOTICE:
Perform reset memory (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM (Click here).

HINT:
Initialization cannot be completed only by disconnecting the cable from the battery terminal.


3.FOR USING INTELLIGENT TESTER

CAUTION:
Observe the following items for safety reasons:

  1. Read its instruction books before using the tester.
  2. Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
  3. When driving the vehicle for testing purposes using the tester, two persons are required. One person drives the vehicle, and the other operates the tester.

4.DISCONNECT AND RECONNECT CABLE OF NEGATIVE BATTERY TERMINAL
D033496E01
  1. Before performing electronic work, disconnect the cable from the negative (-) battery terminal in order to prevent it from shorting and burning out.

  2. Before disconnecting and reconnecting the battery cable, turn the ignition switch off and the headlight dimmer switch off. Then loosen the terminal nut completely. Do not damage the cable or terminal.

  3. When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of the settings.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

← TORQUE SPECIFICATIONS (from Sep 2011)PRECAUTION (from Jan 2012) →