BASIC INSPECTION
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.
| 1.CHECK BATTERY VOLTAGE |
- NOTICE:
- Carry out this check with the engine stopped and the ignition switch off.
| Result |
Proceed to |
| 11 V or higher |
OK |
| Below 11 V |
NG |
|
|||||
| |||||
| 2.CHECK WHETHER ENGINE CRANKS |
|
|||||
| |||||
| 3.CHECK WHETHER ENGINE STARTS |
|
|||||
| |||||
| 4.CHECK AIR FILTER |
Visually check that the air filter is not excessively contaminated with dirt or oil.
|
|||||
| |||||
| 5.CHECK IDLING SPEED |
|
|||||
| |||||
| 6.CHECK FUEL PRESSURE |
|
|||||
| |||||
| 7.CHECK FOR SPARK |
|
|||||
| |||||