2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

BASIC INSPECTION

Troubleshooting · Vehicles built from Jan 2012

When a malfunction cannot be confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by performing the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when performing engine troubleshooting.

1.CHECK BATTERY VOLTAGE

    NOTICE:
    Conduct this check with the engine stopped and the engine switch off.

    ResultĀ 
    Result
    Proceed to
    11 V or higher
    OK
    Below 11 V
    NG

NG.
OK

2.CHECK WHETHER ENGINE WILL CRANK

    NG.
    OK

    3.CHECK WHETHER ENGINE STARTS

      NG.
      OK

      4.CHECK AIR FILTER
      1. Visually check that the air filter is not excessively contaminated with dirt or oil.


      NG.
      OK

      5.CHECK IDLING SPEED

        NG.
        OK

        6.CHECK FUEL PRESSURE

          NG.
          OK

          7.CHECK FOR SPARK

            NG.
            OK

            ← CHECK FOR INTERMITTENT PROBLEMS (from Jan 2012)REGISTRATION (from Jan 2012) →