2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

  1. B310791
    Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

  1. B310792
    Remove the 3 bolts and 2 screws.

  1. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and No. 1 engine under cover.


4. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


A274035E01
Text in Illustration 
*1
Radiator Reservoir
*2
Radiator Cap
*3
Radiator Drain Cock Plug
*4
Cylinder Block Water Drain Cock Plug
*a
for Type A
*b
for Type B
  1. for Type A:
    Loosen the radiator drain cock plug and 2 cylinder block water drain cock plugs.

  1. for Type B:
    Loosen the radiator drain cock plug and cylinder block water drain cock plug.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. for Type A:
    Tighten the 2 cylinder block water drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. for Type B:
    Tighten the cylinder block water drain cock plug.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Tighten the radiator drain cock plug by hand.


5. REMOVE V-BANK COVER

  1. A267633E01
    Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    Hook


6. REMOVE NO. 1 AIR CLEANER HOSE

  1. A267634
    Disconnect the No. 2 PCV hose and vacuum hose.

  1. Remove the bolt and loosen the 2 hose clamps.

  1. Remove the No. 1 air cleaner hose.


7. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

  1. A075597E01
    Disconnect the No. 5 water by-pass hose.

  1. A075598E01
    Disconnect the No. 4 water by-pass hose.

  1. A075599E01
    Disconnect the throttle position sensor and throttle control motor connector.

  1. Remove the 4 bolts, the throttle body with motor, and the gasket.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →