2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ROAD TEST

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


PROBLEM SYMPTOM CONFIRMATION

  1. E107085
    Inspect the SET function.

    1. Turn the main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. After releasing the switch, check that the vehicle cruises at the set speed.

  2. E107086
    Inspect the + (ACCELERATION) function.

    1. Turn the main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. Check that the vehicle speed increases while the cruise control main switch is pushed to +RES, and that the vehicle cruises at the newly set speed when the switch is released.

    5. Momentarily push the cruise control main switch to +RES and then immediately release it. Check that the vehicle speed increases by approximately 1.6 km/h (1.0 mph) (tap-up control).

  3. E107085
    Inspect the - (COAST) function.

    1. Turn the main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. Check that the vehicle speed decreases while the cruise control main switch is pushed to -SET, and that the vehicle cruises at the newly set speed when the switch is released.

    5. Momentarily push the cruise control main switch to -SET, and then immediately release it. Check that vehicle speed decreases by approximately 1.6 km/h (1.0 mph) (tap-down control).

  4. E107087
    Inspect the CANCEL function.

    1. Turn the main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.

      1. Depressing the brake pedal.
      2. Depressing the clutch pedal (for M/T).
      3. Moving the shift lever from D to N (for A/T).
      4. With the shift lever in S, selecting the S1, S2 or S3 range (for A/T).
      5. Turning the main switch off.
      6. Pulling the cruise control main switch to CANCEL.

  5. E107086
    Inspect the RES (RESUME) function.

    1. Turn the main switch on.

    2. Drive at the required speed (40 km/h (25 mph) or more).

    3. Push the cruise control main switch to -SET.

    4. Cancel the cruise control system according to any of the above operations (other than turning the main switch off).

    5. After pushing the cruise control main switch to +RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle drives at the set speed.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2012)ROAD TEST (from Jan 2012) →