2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK INTAKE AIR CONTROL FUNCTION

A151743E01
  1. Remove the V-bank cover.

  1. Start the engine.

  1. A151802E01
    Check that the VSV (for ACIS) is ON (seal) under either of the following conditions below.
    1. Depressing the accelerator pedal to a throttle valve opening angle of 60°.
    1. Racing the engine above 4700 rpm.

      NOTICE:
      Do not increase the engine speed to 5400 rpm or more.

  1. Check that the VSV (for ACIS) is OFF (vent) under either of the following conditions below.

    1. The engine is idling.
    1. Releasing the accelerator pedal while under the VSV (for ACIS) ON condition.

  1. Connect the intelligent tester to the DLC3.

  1. Perform the Active Test, and then check that the actuator rod operates.
    If the result is not as specified, inspect the intake air control valve, vacuum tank and VSV (for ACIS) for normal operation. Replace malfunctioning parts as necessary.

  1. Install the V-bank cover.


CHECK INTAKE AIR CONTROL VALVE OPERATION
  1. Remove the V-bank cover.

  1. A185193E01
    Using a 3-way connector, connect a vacuum gauge to the actuator hose.

  1. Start the engine.

  1. While the engine is idling, check that the vacuum gauge needle momentarily fluctuates up to approximately 40 kPa (299 mmHg, 11.8 in.Hg) (the actuator rod is pulled out).

  1. Fully depress the accelerator pedal, and check that the vacuum gauge needle points to 0 kPa (0 mmHg, 0 in.Hg) (the actuator rod is returned).

  1. Remove the vacuum gauge, and connect the vacuum hose to the actuator.

  1. Install the V-bank cover.


INSPECT INTAKE AIR CONTROL VALVE

A151803E01
  1. Inspect the diaphragm.

    1. Using a vacuum pump, apply a vacuum of 27 kPa (200 mmHg, 7.85 in.Hg). Check that the lever moves.
      If the result is not as specified, replace the intake air surge tank.


CHECK AIR INDUCTION SYSTEM

HINT:
The illustration shows the areas that may draw in secondary air, which could lead to idling problems.


A151789E01
  1. Check that the hoses are installed correctly.

  1. Check for cracks, etc. in the hoses.

← SYSTEM DIAGRAM (Sep 2011 – Dec 2011)ON-VEHICLE INSPECTION (from Jan 2012) →