2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

OPERATION CHECK

Troubleshooting · Vehicles built from Jan 2012


INPUT SIGNAL CHECK
E107860
  1. Connect the Techstream to the DLC3.

  2. Check the cruise control main switch (ON-OFF, CANCEL, -SET, +RES, and MODE) using the Data List function in the Techstream.


INSPECT MODE SWITCH
  1. Turn the engine switch on (IG).

  2. E107861
    Turn the cruise control main switch on. Then push the cruise control main switch to MODE for 1 second or more to change to constant speed control mode. Check that "NORMAL" is indicated on the multi-information display.

    NOTICE:
    Do not push any other switches before pushing the cruise control main switch to MODE. If another switch is pushed, turn the control switch off and repeat the procedure above.

    HINT:
    If a malfunction is detected, turn the engine switch off and repeat the procedure above.


INSPECT STEERING PAD SWITCH
  1. Turn the engine switch on (IG).

  2. Turn the cruise control main switch on. Then push the cruise control main switch to MODE for 1 second or more to change to vehicle-to-vehicle distance control mode. Check that "RADAR READY" is indicated on the multi-information display.

  3. E245428E01
    Turn on the distance control switch of the steering pad switch.
    Text in Illustration 
    *1
    Distance Control Switch

  4. E245426E01
    Check that the indication of the vehicle-to-vehicle distance, which is shown in the multi-information display on the combination meter, changes from long to middle to short in that order.
    Text in Illustration 
    *1
    Multi-information Display
    *2
    Long
    *3
    Middle
    *4
    Short

    HINT:
    The indication is automatically set to long each time the engine is started.

← ROAD TEST (from Jan 2012)PROBLEM SYMPTOMS TABLE (from Jan 2012) →