INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT WATER INLET WITH THERMOSTAT |
- HINT:
-


- The valve opening temperature is inscribed on the thermostat.
Immerse the thermostat in water, then gradually heat the water.

Check the valve opening temperature of the thermostat.
- Standard valve opening temperature:
- 80 to 84°C (176 to 183°F)
Check the valve lift.

- Standard valve lift:
- 8.0 mm (0.315 in.) or more at 95°C (203°F)
Check that the valve is fully closed when the water inlet with thermostat is at a low temperature (below 77°C (171°F)).
If not fully closed, replace the thermostat.
