INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart (Click here).
- Use the same procedures for the LH side and RH side.
| 1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY |
for 9 Speakers Models:

Connect the connector.
Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
Install the speaker with the 2 bolts.
- NOTICE:
- Do not touch the cone part of the speaker.
- When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.
- Do not touch the cone part of the speaker.
except 9 Speakers Models:


Connect the connector.
Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
Install the speaker with the 2 bolts.
- NOTICE:
- Do not touch the cone part of the speaker.
- When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.
- Do not touch the cone part of the speaker.
| 2. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY |
![]() ![]() |
Attach the 4 claws to install the panel.
| 3. INSTALL FRONT PILLAR GARNISH LH |
![]() ![]() |
for 9, 14 Speakers:
Connect the speaker connector.
Attach the clip and 3 guides to install the front pillar garnish.
| 4. INSTALL FRONT ASSIST GRIP SUB-ASSEMBLY |
![]() ![]() |
- HINT:
- Use the same procedure to install the front assist grip on the other side.
Attach the 2 claws to install the front assist grip.
Install the 2 bolts.
Attach the 4 claws to install the 2 assist grip plugs.

| 5. INSTALL FRONT NO. 4 SPEAKER ASSEMBLY |
Connect the speaker connector.
Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.
Install the speaker with the 2 bolts.

- NOTICE:
- Do not touch the cone part of the speaker.
- When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.
- Do not touch the cone part of the speaker.
| 6. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY |
![]() ![]() |
Attach the 8 claws to install the opening cover.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).




